Client: MIRANDA KERR

SKETCH IDEAS

An investigation into circle patterns and potential building forms. 

Link below:

The first creation of the model in Sketchup.

Modelling the potential position for pressure screws.

 Water tight Detail above.

The Making of the water tight walls pressure sealed in sketch up.

PULLY SKETCH IDEAS 

The new square walk in wardrobe.

I feel it works better with the overall composition. 

I tried to 3d print a s spiral staircase for access but the print did not go to plan.

The beginning of the display case from laser cut perspex and a prototype silicon sealed 

small display case.

Experimenting with wood to create the pulley system.

From a wooden pulley frame to a copper wire one,more tests will be carried out.  I think maybe more strength is needed, 

I decided to use a metal frame made by flattening the metal tubing into supports, solder them together and solder copper loops onto it to support the wheels. Soldering was rather tricky as it required allot of time, patience and technique. 

Soldering time-lapse.

A second smaller pulley has been added to increase efficiency.

Pulley display unit inside the inner display case.

Finished pulley system time-lapse.

 At the end of the cat walk there will be illuminated boxes that she can view individually at her pleasure.

Box Time-lapse.

Next i made the LED circuit for the illuminated boxes.

I put the LED's inside the boxes with the positive and negative feeding out.

I then soldered the wiring to the LED's making sure the positive wire went onto the positive long LED leg and on one box i had placed it the other way round. This was later corrected,

I also spray painted the red wiring silver for effect.

Inside the larger display case.

The top and bottom MDF plates have been cut to size with the threat holed drilled and beveled.

The thread will be tightened at both ends to compress the display case together creating a tight seal.

THE FINAL MODEL:

THE END.